When we need to some stone, density board carving will be used when the computer engraving machine, computer engraving machine is still a wide range of applications. It is not important in the use of the process if you do not pay attention to its maintenance, it will make the machine failure, affecting the normal use function. So in order not to affect the use of computer engraving machine function, it is very important for the maintenance of care.

First of all, the user should regularly defragment it, and optimize the computer system. To conduct regular virus killing on the system, but remember when the work cannot open the antivirus program, because this work is vulnerable to interference.

Secondly, after the completion of the carving work, in order to facilitate the next work must pay attention to the table clean and tidy. Should pay attention to regularly clean up some debris in the guideway, so to prevent debris interference resulting in engraving machine appear lag.

Then, the dust above the cabinet should also remember to clean regularly, so that the heat can be good, but also to prevent the abnormal industrial card. Computer engraving machine when not in use, at room temperature is relatively low under the condition of the best water in the water tank is drained, to prevent cracking phenomenon.

Finally, regularly check the standard temperature of the oil to be added. At least its lowest temperature. Screw has to be cleaned regularly, prevent dirt stuck up.

As long as we do the above maintenance work, then it can be very good to reduce the frequency of failure of computer engraving machine, and can guarantee the life of engraving machine at the same time, better service for us